L/C Meter Case
rare_branch
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2015-10-01 11:25:22
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
Summary
This is a case for the LC100-A L/C Meter found on ebay. It is commonly used in the RC hobby to test motor windings for shorts.
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
0.01
Infill:
15
Notes:
The case is printed with supports. It can be printed upside-down to reduce the amount of support material but then you end up with a rough surface finish around the buttons. The example was printed on an Ultimaker 2 in PLA @ 215 degrees.
Post-Printing
The base screws to the meter with 3 mm screws (4 mm long) and is held in by the tabs.
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY