This is a selection of 3D printable magazines with a 13.5 degree angle. This mag has the same geometry as a Worker Angled Talon.

These mags were derived from a reference model made by Adrian Kelly.

All three variations require a "drum spring". They also need a small amount of glue near the top of the seam between the front and rear halves of the mags to hold them together.

The 10rnd and 15rnd mag use 4 M2.5x10mm coarse thread screws (known as "nerf screws" or "toy screws" in the hobby) to secure the base.

The Gecko mag uses 3 M3x12mm socket head cap screws to secure the base.

Note: The instructions images only show the "Gecko" mag. The steps are the same for all three versions, just replace the baseplate and screws as noted above.

Update July12 2021:
Added a 3D printed bumper that can be installed onto Worker Angled Mags. This is for those who want the look of the Gecko's printed mag for their Worker mags.