cap for threaded garden hose, etc, etc, etc
the stlhosetap is just used in the hosecap stl file, saves a lot of rendering time.

I printed this at 0.2mm 25% fill layer height, I suggest printing it SLOW.

I expect SOMEONE to modify this into something.

1) Print the cap
2) cut out a small plastic disc that fits in the bottom of the cap
3) put the disc you just cut out into the bottom of the cap
4) put a gasket in there.
5) enjoy your hose cap.

I printed mine is PLA and tested to 60psi and it was fine, didn't even leak