Share the model. If there's any infringement, please contact us to remove it. DO NOT CHANGE THE Z-HEIGHT. For ease of use, I suggest unchecking the "UNIFORM SCALE" and only changing the X and Y percentages when editing the size.

Print at 100% infill with a layer height of 0.08mm and a base layer of 0.16mm.

You can print at higher layer heights below the Min Depth of 0.48mm.

The maximum depth is 2.2mm, and the actual depth is 2.2mm.

Filaments Used:

PLA BambuLab Matte Charcoal Transmission Distance: 0.6

PLA BambuLab Matte Scarlet Red Transmission Distance: 2

PLA BambuLab Matte Lemon Yellow Transmission Distance: 4

PLA BambuLab Matte Ivory White Transmission Distance: 3.5

This print uses 4 unique filaments.

Swap Instructions:

Start with Charcoal

At layer #17 (1.44mm), switch to Scarlet Red.

At layer #21 (1.76mm), switch to Lemon Yellow.

At layer #23 (1.92mm), switch to Ivory White for the rest.