I wanted a simple belt clip to wear in time for May the Fourth. Unfortunately, what could find didn't fit the sabers I had, or were more complex than I wanted to print at the time. So I designed this!

I printed it in the orientation of the file (upright) without the need for supports. You may need to separate the belt clip part with a hobby knife.

It is designed to fit my 30mm/1.1875" wide belt.

I have tested it, and it works with the following sabers:

UnimatrixRed's Qui-Gon Jinn Lightsaber

ceo51378's Obi-Wan Kenobi Episode 1 Lightsaber

CaseStudyno8's Stormtrooper Lightsaber

I'll add to the list as I print and try out more. Apparently, most of my sabers have D-rings!