Lets you mount an IKEA Lönsås 210x300mm mirror to the back of the printer, to easily inspect prints for issues.

The mirror can be angled, the arms should clear the bed heater cable, and the arms are attached by sliding brackets for easy removal.

Required hardware:

• 2 M4 hex head bolts

• 2 M4 heat set inserts

• IKEA Lönsås ~ 210x300mm or equivalent mirror. 

  • https://www.ikea.com/se/en/p/loensas-mirror-50471026/

• Glue (parts are separate for improved print-ability)

• Spacers and/or springs to preference

• (Re-uses four bolts from the SV06+ rear plate.)

Print settings:

• Print on flat sides

• 5% gyroid infill

• Snug supports everywhere

• Vertical perimeters: 4

• Horizontal perimeters: 4 top, 2 bottom