Filter for rainwater for an IBC container

The aim is to filter the water well. If the super-fine filter clogs, the water flows through a somewhat coarser filter. I use moss or straw to make clogging of the filter even less likely.

The fine filter is created by the print profile. Be carefull if you touch the print profile.

The mesh in the lid is fine enough to keep out mosquitoes.

You can also use the lid alone.

The model fits for 30mm diameter hose. The hose is fed through a separate insert. If requested in the comments, I can also provide profiles for other hose sizes. This insert also makes it easy to clean the filter.

I used white PETG to improve the durability. But I'm confident that PLA should work out fine, especially if not placed in direct sun.