This model was designed to be easily printable on a Prusa Mini+.
For this reason, the overall dimensions are optimized for the build volume of this printer. Another key design goal was to allow printing with as few supports as possible.

Description

This cable hook was designed as an optional accessory for other 19" rackmount  accessoirs. It should help with clean and strain-relieved cable management inside the rack.

Printing Instructions

The model is optimized for FDM printing and can be printed without supports in most orientations.

Mounting Instructions

For mounting the cable hook, the following hardware is required:

• 1× M4 threaded insert (heat-set insert) - The insert used for this model is available from CNC Kitchen.

• 1× M4 × 12 mm screw

Install the threaded insert into the hook according to the manufacturer’s instructions, then attach the hook to the rackmount bracket using the M4 screw.

If you print and use this part, feel free to share photos of your setup.