A bracket for attaching a Lenovo IdeaCentre miniPC to double-c-track (in my case, to an Ender3v2).

The model has been updated since my original (pictured) print. The original print was 5mm shorter than intended (math/measuring is hard--oops).

This pairs nicely with M5 x 20 series-TSlot bolt and M5 nut to attach it to the c-track. The mounting hole is 6.5mm, a bit oversized (intentionally) but works well with an M5 bolt and nut.

The top of the bracket has a hole which is intended to be tapped and a plastic M5 bolt installed and snugged against the miniPC case. This hole may need to be drilled out before tapping, depending on how tight your print ends up.