Nice inlaid coaster. 101.60mm x 101.60mm x 3.17mm or 4" x 4" x 1/8" Printed well just make sure you have your glue or adhesion material completely under the print as the corners are very thin and will curl if you don't have good adhesion. Also you must trim the bottom of the (Shield and weapon inlay) pieces only the sword handle and the axe handle and axe head need attention the shield and Sword blade fit perfectly, then super glue them into the coaster.

Grizzly G0923

No

No

2.0

15

Printed well just make sure you have your glue or adhesion material completely under the print as the corners are very thin and will curl if you don't have good adhesion

You must trim the bottom of the (Shield and weapon inlay) pieces only the sword handle and the axe handle and axe head need attention the shield and Sword blade fit perfectly, then super glue them into the coaster.