Laser Pipe Filament Runout Sensor

Provided as is:

This uses a small Laser to pass light through a transparent Bowden Tube Pipe to detect if the Filament has Runout or snapped.

No need to have any break in the Bowden Tube maybe good for flexible filaments.

I doubt if transparent filament will work with this.

There is a part for a small microswitch to be fitted to switch Laser off if the lid is opened for safety.

New Optical Filament RunOut Pass Through Tube Sensor works, manual testing https://youtu.be/NdZg186fbuE

Create an Optical Filament RunOut that will not require a break in a Bowden Tube*, ideal for flexible filaments and easier to feed filament into, etc..

• For use with a clear Bowden Tube

Clear Bowden Tube see your filament https://youtu.be/ldfTFoZWonM

Needs some more work to try to to make it easier to set up, has to be adjusted just right.

Could be made smaller, I have plugs inside that could be wired in directly saving space.

I used

The Detector>

Laser Receiver Module non-modulator Tube Laser Sensor Module UK Arduino PI UK https://www.ebay.co.uk/itm/272875894591

The Laser>

650nm Laser sensor Module 6mm 5V 5mW Red Laser Dot Diode Arduino & Raspberry Pi https://www.ebay.co.uk/itm/181973250215

1M Clear Heat Resistance PTFE Tubing 2 × 4mm

For RepRap Prusa 3D Printer L5M0 https://www.ebay.co.uk/itm/282655266785

Category: 3D Printer Accessories