Overlord Pro wire chafe guard
Jemma Ridley77
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-01-09 16:46:08
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
On the Overlord and Overlord Pro, wires can chafe against the metal shield around the top of the hot end. This object protects the wire bundle from the sharp edges of the shield.
Print Settings
Printer:
Overlord Pro
Rafts:
No
Supports:
No
Resolution:
0.1mm
Infill:
10 - 15 %
Notes:
Depending on the surface finish you might want to sand the curved bottom to smooth out any imperfections from printing.
Print at 0.1 mm, no support needed.
remove the 4 screws holding the shield on, and snap in from inside the shield. ( The two screws closest to the angled fan don't need to be removed)
Reinstall shield: tighten the side with two screws first, then the side screws.
Category: 3D Printer AccessoriesModel Kaynağı
Orijinal Link: Detayları Gör
CC-BY-SA