Printed from TPU so it is pliable, this tiny gadget will prevent that pocket fuzz from getting up inside the charging port of your iPhone. Since my phone uses a Qi charger, I seldom ever need the port and more than once I've had to be creative in getting pocket lint out of the phone when it would not fully plug in. The beveled edges make it easy to use your fingernails to remove it.

Creality

Ender 5

No

Yes

Fine

none

Make sure you use a good temperature for layer adhesion. It is very small. I printed it on its side using supports to ensure the banding wouldn't break off inside the phone. I don't recommend you print it vertically to not use supports.