Have a QLG1 GPS for a WSPR radio? Don't know how to remote it away from the radio? Well, now you have a case to at least try and do this.

The "bottom" side has a 15mm (5mm thick) "punch out" if you want to convert the QLG1 to use an external antenna, just punch out the hole, and feed a cable to the SMA connector.

I'm still testing the case, so it may change in the next few weeks, just an FYI.

Print Data -STL's sliced at .16mm 50mm/S with a .4mm Nozzle, walls at 1.2mm, 20% infill.

Top - 32 grams, 10.88 meters of filament, time to print 4:44
Bottom - 32 grams, 10.94 meters of filament, time to print 4:34
Clamp - 1 gram, 0.48 meters of filament, time to print 0:17

Version:
1.1 - Reduced the outsides of the case from 3mm to 2mm
1.0 - First release - have at it.

Creality

Ender 3

No

Yes

.16

Standard 20%

Supports are only needed for the TOP case, due to the screw holes. Print face down, the slower the better, since it is a box with a lip. You may need to square the corners with a file to get the box to fit together.

File the corners to get the two sides to fit.