Diy battery pack to my (chinese gd95 from TEMU) drone.
01,11,2024 Aded new file.AKKUNEWC.stl and 3 mf
I got the right battery (socket) connector. and i did a little modification .

Attention!!!
This is not a how-to guide, this is how I did it!!!!
Its NOT a toy
Do it at your own risk!!!!
Only do it if you know what you're doing!!!!

PROTOTYPE
Stuff I used for this project,
PLA-filament , (some noname)
PCB female-header,
a piece of PCB Single Sided Circuit Board /hole board
some empty (vapor) wapor's or HQD's battery (by my Son)
(in the final version ill use PETG filament, and li-po 3.7v 750mah 602158 X2 )(or similar etc.....)
"TP4056 Charging Module" usb -"C" type
//I don't use the output on it /only for charging/
This small module's output cannot handle as many Ampers as the Drone needs and the
drone has low voltage protection, and will turn off ....etc.//

the PCB: i glued down by soldering iron /as a proto will do/
Drawn in MS. 3d-Builder
uploaded in 3mf and stl
3 different versions.
only shape(dummy), with, and without pcb-place

NOTE:

if you decide to build it,
Carefully!!

Building a battery pack is no child's play,/even this small one/

do not short it !
measure, measure, measure!!
insulate! insulate! insulate!
and don't reverse the polarity because your drone will smoke!
Use protective equipment
use appropriate and safe tools.
Keep these in mind

Artillery

Artillery Sidewinder X2

Doesn't Matter

Yes

0,16

does not matter