This is a servo probe mount that is used with the sg9 servo, the 9g servo such as tower pro servo. fairly simple, and requires you to have an m3 screw and nut that will clamp on the servo rod.

Here is the video about how to solve problems on auto bed leveling z axis not going down further than the probe https://youtu.be/SUBDDn-mfrQ

Doesn't Matter

No

.2mm

10%

Config.h settings

Auto bed leveling section - http://pastebin.com/c6q2j9yb
The probe offset are set to the tip of the mechanical switch and the tip facing front, do refer to the video for the orientation

Servo setting - http://pastebin.com/YpKT9fLc
The servo mounting and cable facing to the x carriage, do refer to the video as well.

This were primarily made for my extruder groove mount, but also fit on other servo and other kind of setups though, just tighten the screw near the mounting hole