Description

What i changed ?

antena holes are moved 1mm higher

display hole is smaller

side button is better protected

pre-marked hole for power LED and antenna LED

so if you print out of the translucent material, you will see the antenna red and the power green circle shine through

or if you use black or not translucent material, you can drill holes with a 1.5 mm drill bit, then fill the hole with translucent material (I used superglue mixed with flour - as you can see in the photos)

Please use PETG, nylon or some kind of semiflexible filament

Its not good to print it out of hard filament like PLA, because its tight fit and it will be hard to remove this cover, if it will be necessary

I printed it from Fiberlogy nylon black, 0,15 layer high.