I have a wall that does not work with Displate's mounting solution. So I had to make my own mounting solution!

Printing settings:

• I used PLA filament with a 100% infill setting.

Required materials for assembly:

• 20 mm diameter neodymium magnets (or 10 mm radius).

Mounting instructions:

1. Push the magnets into the mount (they friction fit just fine).
2. Keep the mount level and mark the wall through the mounting holes.
3. Use a nail or screw to affix the mount to the wall through the mounting holes. The head of the screw or nail should be below the elevated squares the magnets are fit into.

NOTE: If you use screws it might be better to manually screw the mount into the wall. I had some issues with mounting it to be level with the wall. The holes are also smaller than most drywall screws. So you will have to be careful when screwing through the mount.