Summary

This is a E3D Titan mount for the Makerfarm Pegasus 3D Printer, which leaves enough room in front of hotend to make it easier to fit more print fan designs. This was designed for the Pegasus 8'' model with metal carriage, may work for other versions as well, not sure. The design was designed in OpenSCAD, so it is easily customizable if you would like to move the extruder position according to your liking.

This mount goes very well together with the fantastic Radial Fan Fang (https://www.thingiverse.com/thing:2175956). The original Titan mount sent by Makerfarm did not leave enough room the front of the hotend.

Advantages:

• More room in front of hotend to use print fan
• Easier access to extruder gear
• Easier access to idler for loading/unloading filament
• Uses all 3 screw holes on metal mount, so it is very stable.

Disadvantages:

• Harder access to idler tension screw, it is not too hard to access though, and your not supposed to change it a lot.
• Hotend moves slightly to the front of printer, so Y endstop might need to move to regain the print area.

Parts needed:

• 2 x 15 mm M5 screws (top holes of x carriage, put in from the front)
• 1 x 10 mm M5 screw (bottom hole of x carriage, mounted from the back)
• 2 x M5 lock nuts (behind top holes)
• 1 x M5 nut (Goes in behind the extruder motor, i designed a nut trap behind it, when you put a normal M5 nut.)