**DISCLAIMER***

PRINT AND USE THIS AT YOUR OWN RISK. I WILL BE IN NO WAY HELD RESPONSIBLE FOR ANY ACCIDENTS OR INJURY CAUSED FROM USING THIS TOOL.

BY DOWNLOADING AND PRINTING THIS TOOL YOU ACCEPT ALL RESPONSIBILITY AND LIABILITY FOR ANY ACCIDENTS AND OR INJURIES.

This is a stabilizing base that goes on a standard gas cylinder to help it from tipping over. The tall thin torch cylinders can be a bit wobbly and tippy so I wanted something to help stabilize it. The cylinder should be a snug fit but based on your print settings it could be a bit too loose so I added a retention screw to help keep the fit snug. I have added 3 variations of retention screw as the thumb screw may not be suited to people with larger hands. If this is the case, I would recommend using the slotted thumb screw or the hex screw.

I would use at least 25-30% infill to help it be as rigid as possible.

**The retention screw and screw hole need to be worked in and out a few times after printing to help them fit properly. the fit will be very tight but will loosen up after a few times in and out. Screw it in from the inner side first a few times until it is able to pass through, then you can assemble it properly from the outside.

The print in the pictures was printed on a high speed setting so the quality is not great. You can see the top of the pint has separations which will not be in the print at normal settings.

**DISCLAIMER***

PRINT AND USE THIS AT YOUR OWN RISK. I WILL BE IN NO WAY HELD RESPONSIBLE FOR ANY ACCIDENTS OR INJURY CAUSED FROM USING THIS TOOL.

BY DOWNLOADING AND PRINTING THIS TOOL YOU ACCEPT ALL RESPONSIBILITY AND LIABILITY FOR ANY ACCIDENTS AND OR INJURIES.

Creality

Ender 3

No

No

.2mm

25-30

**DISCLAIMER***

PRINT AND USE THIS AT YOUR OWN RISK. I WILL BE IN NO WAY HELD RESPONSIBLE FOR ANY ACCIDENTS OR INJURY CAUSED FROM USING THIS TOOL.

BY DOWNLOADING AND PRINTING THIS TOOL YOU ACCEPT ALL RESPONSIBILITY AND LIABILITY FOR ANY ACCIDENTS AND OR INJURIES.

The screw has to be worked in and out to help achieve a proper fit. start from the inside hole and move to the outer hole once the screw moves freely.

**DISCLAIMER***

PRINT AND USE THIS AT YOUR OWN RISK. I WILL BE IN NO WAY HELD RESPONSIBLE FOR ANY ACCIDENTS OR INJURY CAUSED FROM USING THIS TOOL.

BY DOWNLOADING AND PRINTING THIS TOOL YOU ACCEPT ALL RESPONSIBILITY AND LIABILITY FOR ANY ACCIDENTS AND OR INJURIES.