After almost one year of manual (and painful...) bed levelling I've finally got a crtouch for my ender5pro, but I had this printer upgraded to the microswiss direct drive (shortly after buying it), so I needed a mount which could fit my setup. Thankfully this one was perfect, I just had to carve a little notch in the middle to allow for the crtouch wires which are not exactly in the same spot as the bltouch.

I did it in a very "rough" way editing the stl file with openscad, this is not always possible, some premade stl files literally explode when trying to modify them in openscad, but this thankfully worked well, printed, and happily using it :)

P.S.: the X and Y offsets I had to put with + sign instead of - sign, idk why maybe the firmware has flipped axes... so:
Y: +17.5 mm
X: +43.8 mm
for Z instead I decided to not change the stock value of the creality "Ender-5 Pro- Marlin2.0.1 - V1.1.1 - BLTouch.bin" firmware, I've ended up with a manually put -0.550 z offset and that works well for me

Creality

Ender 5

No

Yes

0.2

100

Put 4 walls
And put normal supports only in the notch, like in the picture.
For all the other holes I've just put a support blocker in cura and set the fan to 10% (I usually keep it at 0% for PETG, but it helps to have a bit with overhangs).