Blinder holder
OchreFoundry5
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-03-11 06:21:25
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
Two of these small plastic clips hold the blinders down. Good especially if you have the blinders on a door because otherwise the blinders will swing and potentially break.
Naturally this kind of small parts break in due time so here is a new version. Originals where poorly designed to say the least. There is a piccy of original broken one too.
Both sides are symmetric so just 2x print the same part in case old ones are broken.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2.5
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
I used 0.2 layer
Infill:
I recommend adding 100 infill to certain parts. See the slices file .
Filament Material:
PLA
Notes:
PLA will not last well so use ABS instead. I just happened to have PLA so it will last 1-2 years in the sunshine ... maybe...
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC-BY-SA