Summary

I don't recommend using this part, so I've taken away the remix link back to the hopper (https://www.thingiverse.com/thing:4386326).

I set this as being a work in progress because it creates more horizontal distance for material to be pushed along, and doesn't work as well as I'd hoped. Also, the short side is really weak. I no longer use this part, since I pulled all the electronics out into a separate box and don't need this angle adapter to be able to see and access the Filastruder controls.

The hopper didn't fit on my Filastruder for some reason. Too close to the casing. I also wanted to move the hopper to the side a little, so that the temperature control panel is unobstructed. So, I designed this part to go between the hopper main body, and the back clamp part. One nice thing is that it's now possible to remove the main body and leave the clamp in place.

Currently, the model is designed with holes small enough to hold M3 screws, but it's hard to get the exact right length that will work on the short side because they can interfere with each other. I'll see about strengthening that, but it might remain as is if it works reliably in operation.

Update 6/13 - Added v2 model with pockets for square nuts.