This is a custom case for Intel NUC 5 industrial boards with dual display ports that do not have a case.

This was a whimsical project with some obvious flaws like this case needs extremely long screws and doesn't have a good 2.5" drive mount. On the one hand I could have gone to ace hardware and got long enough screws but hot glue worked just as well to close the lid and electrical tape to hold the 2.5" ssd in place. It's not great but I am attaching the fusion 360 model for others to pick up the model if they want to.

To raise the mini pc off the ground, I used small pieces of 1/4" thick weather strip foam as feet in the four corners.

Good luck!

No

No

0.28

20%

Please use your best judgement for your 3D printer.