I didn't want a lock, just something to keep the cub-bard closed. Remixed to make the end round, and the back a little stiffer. Also designed a strike plate, one flat (and untested) and one to go on a 1x4 or 1x6 (which can be seen in the picture). Just a friction close to keep cub-bard doors from drifting open. Mount the latch where it gives an appropriate amount of friction on the strike plate and doesn't jam when they meet. mounted with #6 screws.

Tevo Tarantula

No

No

0.2

20%

even though infill was set to 20%, slic3r did print it solid due to the minimal layer area.