Sliding garden rakes from soviet era.
If you would like to thank me financially: https://boosty.to/carapovich/donate

For the complete assembly you also need:

• 3 pcs. screw M3x10,
• 3 pcs. nut M3,
• 1 pc. 10mm length compression spring with Ø1mm wire, Ø8mm outside,
• 1.8 meters of Ø2mm steel wire for rake tooths.

Compression spring link: https://aliexpress.com/item/32885805936.html.
Steel wire Ø2mm link: https://aliexpress.com/item/1005004632141213.html.

Assembly

1. Cut steel wire on 6 pieces by approximately 300mm length.
2. Bend the wire pieces as shown on the picture (don't forget to cut off the excess).
3. Put the carret in the bottom body part, after that insert all 6 rake tooths in the carret and fasten them with the clamp.
4. Insert the spring into the top hole of the carret and close the assembly with the top body part with the slider inserted.
5. Finish assembly using nuts and screws.
6. Enjoy!

Printing details

• Body parts should be printed with supports.
  Use minimal Z-gap for the top layer of supports (I used a layer height of 0.12mm and the same Z-gap)
• Other parts can be printed without supports.

Doesn't Matter

Yes

0.12mm

25%