Adjustable inner / outer corner / straight shelf
Dorothy Underwood
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2023-10-11 21:27:41
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
Summary
This shelf ables to ensure that uneven corner doesn't disturb shelfs rigidity. I didn't really wanted to drill my wall with holes, so i designed this shelf to satisfy my requirements! You can always edit this part if you want so or remix freely. To mount it you just need at least 8 stripes of thick (2mm) double sided tape. And 2 M3 screws, inserters/nuts.
upd: added step files.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
Yes
Resolution:
0.2mm or finer
Infill:
20% Gyroid
Notes:
IMPORTANT! Make sure that you are using there GRID support interface in adjustable part. In unfortunate case you could ruin adjustment part or damage it.
Support placement everywhere.
Post-Printing
After that adjustable part comes printed out you need to gently bend it till' it moves relatively freely.
Remember to install double sided tape and if needed make more even surface on adj. part.
The shelf itself is using M3 heat inserters. for 90 deg you just need only two which is near to edge.
How I Designed This
There is two part body which where you can see axial going through other body.
Custom Section
Slicer setup
Place model like that:
Example make:
It seems pretty rigid and approx. max load i think is about 700-1200g, but didn't tested too much. Still, durable!
Design custom shelf!
To design it, you need to place at least two 3.2-3.5mm holes on 81,394mm circle and go ahead.
It can be:
- Circle like shaped
- Straight shelf
- Below mount point bookshelf like shelf
This is only startpoint to really make something beatiful, i really hope that i invented something cool.
(sorry for uneven dimension there...)
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY-SA