This is a simple, single-screw wall hook that uses very little material. I originally designed this for hanging my pans on my wall, so durability was a must.

I printed these in both PLA and PETG, the PLA prints were surprisingly strong, but I would recommend using PETG if it's going to be hanging anything heavier.

Settings used:

• Black Prusament PETG
• 0.2mm Layer Height
• 0.45mm Perimeters
• 15% Grid Infill (infill isn't really that important for this print)
• 225°C Nozzle first layer, 250°C for other layers
• 90°C Bed for whole print
• 5mm/s First Layer