This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/kaEpJRZYU9V

Make 4 of these to raise your Solidoodle up 5 ins So you can put power supplies or spare filament rolls or whatever under your machine. I printed these at .2 infill and .3mm ,Then I glued Neo maagnets to the tops and small rubber feet to the bottoms . power supplies are screwed to bottom of my SD3.These are somewhat overkill in strength they take about 13 hrs each to print.

Instructions

I printed these at .3 mm with .2 mm infill and support enabled.Print four and attached with double sided tape or drill holes and use screws or glue Neo magnets to the tops and small rubber feet on the bottoms. You will need to print 4 of these Be forewarned these are 13 + hours each .I made them very heavy duty!!

Category: 3D Printing