This is a wall mount for the “P6 Automatic Soap Dispenser”. It already comes with a wall mount, but the mount is made out of some sort of extremely slick plastic that I can't get to stick to my double-sided VHB tape. This wall mount fixes that problem.

Printing

Any material. Slice as oriented in the model. Supports required.

I'd suggest a smooth bed, a print on a textured bed didn't stick to the VHB very well.

Assembly

Remove supports.

Sand the backside of the mount with sandpaper (grit doesn't really matter) until the entire surface is roughed up.

Apply a strip of VHB adhesive along the top, the full width of the mount. Apply two shorter strips of VHB adhesive down the sides.