My wife and I use the wide angle attachment on our dyson quite often when vacuuming couches, stairs, etc. She suggested I design/print a clip to hold this attachment with the vacuum all of the time instead of in the closet with the other attachments. This was designed in inches, if it comes into your slicing software very small, just multiply the scale by 25.4. I used 4 M4 button head screws to attach the two halves/clamp the clip to the handle. The screws threaded into the plastic and it seems pretty sturdy, but if the force of pulling the attachment off strips out the screws, I will just use a slightly longer screw and put a nut on the back side. Let me know what you think and post those makes!

Creality

CR-10S

No

Yes

.2mm

30%+