This is a remix of the original Pi Zero 2W + Pi Camera Y-axis mount, modified to support the Arducam Rev.C OV5647 CS (B0032). 

The camera mount has been realigned so the larger CS-lens housing clears the nozzle and frame without collision, while keeping the same compact footprint and clean cable path as the original. 

From what I can see, other Arducam models share the same board width/height, so this remix may be compatible with additional Arducam variants as well. 

The mount still attaches to the Y-axis end using two M3×16 mm screws and does not interfere with any moving printer parts. It remains a neat way to run OctoPrint or Klipper directly on the printer using a Pi Zero 2W and attached camera.
 

Requirements

• 2 × M3 × 16 mm screws (replace the stock Ender screws)
• Your preferred Pi Zero (2) case lid from the original design:
  https://www.printables.com/model/267909-raspberry-pi-zero-zero-2-case-snapfit-screwless-in
• Camera (Arducam Rev.C OV5647 CS B0032)

Information about the camera:
- https://docs.arducam.com/Raspberry-Pi-Camera/Native-camera/5MP-OV5647/
- https://www.uctronics.com/ov5647-camera-board-w-cs-mount-lens-fully-compatible-with-raspberry-pi.html