Hey guys! I am new to this CAD journey. I've made lots of pre made designs but never made my own.

Recently started a new hobby of CAD design and I am absolutely loving it. This idea came with a safety issue i was concerned about with my smallish workshop while doing laser engraving/cutting. I would bump my laser or the table knocking it out of place and I would spend a significant time trying to “square” it back in place.

This is V1 of this and there will soon be a V2 with different mounting points

Instructions:

• Remember to always disconnect power while working on your laser engraver.
• Slide the mounting brackets on the Xtools legs (Keep anti-vibration rubber pads on)
• Make sure there is a suction fit
• Mark out where you want them
• Screw on the brackets with a pan head screw
• lay laser in brackets 
• DONE!

It was made with Elegoo PLA