I created this to protect the Launchpad board, used in BLE sniffer project: https://github.com/nccgroup/Sniffle 

Compatibility

Case is designed to work with all sizes of the supported boards as they come from the factory. This means that for the shorter boards, this case is larger than needed. This case is also quite tall, due to the headers assembled to the board. 

Case was tested with short and long variants; CC2651P3 and CC1352P

With some modifications to the board, you could make the case a lot smaller. I didn't want to have modifications as requirement to keep your board safe, so decided to make it a bit larger to fit the board as it is.

Top options

There are two designs for the top; default and hex

Only difference is the Bluetooth logo pattern.

Assembly

Assembly requires just two M3 screws. Board should stay quite well in place with just the two screws, as the lid has two contact points in the middle of the board.