I got a Monoprice Strata Sous Vide immersion circulator, but don't have any good place to keep it and wanted it handy as I find I'm using it a bunch, so I made this bracket for it. The screw holes are sized for #8 screws. On the right is a ledge for hanging the clamp and on the left is cord storage. This should also fit the Anova circulators and maybe others that are 65mm in diameter or less.

Note: It is not a snug fit, but I just want it to hold, not struggle to get it in and out. you can probably add a piece of foam weather stripping or something if you want a tighter fit. I also ran it through Meshmixer and added my own supports for the power cord stanchion because the Slic3r support generator was just about useless. The screw holes should accept #8 screws, but will require a little persuasion or an appropriate drill bit as I made the tolerances a little tight.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.3 mm Layer height

Infill:

Filament: Don't Remember PLA Gold

Notes:

Category: Kitchen & Dining