This is a case to hold a night vision camera like those sold by www.electreeks.de, the one linked to below specifically together with a Raspberry Pi Zero 2 W. It comes with a tripod mounting point. As the camera does not have any mounting holes, I designed a clamp to hold it in place. That's the little bar like part ;) 

Obviously for indoor use only …

Hardware required:

• 4x M3x15 countersunk heads for the case
• 4x M2,5x5 NOT countersunk to hold the Raspi. 
• 1x ¼ inch by 20mm threaded insert for tripod mount. 

Printer used: Original Prusa MK3S+

Filament: PLA or whatever you like

Printing instruction:

Layer height: 0.2mm
Supports: yes, supports on printbed required

Fusion360 File provided as-is, have fun!

Camera: 

https://electreeks.de/shop/raspberry-pi-kamera-nachtsicht-mit-infrarot-sperrfilter-175-grad-weitwinkel-objektiv/