Spinning Glasses Display

Printer: Bambulabs P1S

Material: PLA

Nozzle: 0.4mm

Layer Height: 0.2mm

Infill: 25%(Peg's and CenterRod should be printed at 100% infill)

Infill Pattern: Adaptive Cubic

Supports: Normal(can use tree, whatever you prefer)

Brim: Only for CenterRod, or if you are having adhesion issues printing the Pegs

Walls: 3

Requires 1 608 Bearing. Sides are marked with numbers for the order they slide onto the CenterRod. Print 14 PegCapped, and 2 Peg(for side 2 and 3, center holes) CenterRod is recommended to be printed laying down with supports

Note This was requested to be created, has not been tested by me but has been said to work. By not tested by me I mean I did not fully assemble this and put glasses on it, I test all parts mechanically.