Inspiration

I wanted to be able to mount a Raspberry Pi (3 B+) directly underneath the area occupied by Codemonkey1973's Pi Camera Mount in order to use a cable chain without weird bends or twists outside a case. Additionally, I wanted to fasten a ribbon chain cable to the case with the least number of bends/twists possible.

As for cases, I tried out J741's mounting scheme and while it worked, it would be a difficult to remove from the printer without removing the pi and the lid wouldn't stay on. Keleo's case had a great mounting method but the case itself didn't fit the pi very well and I wanted the longer side of the case to point up.

Each idea had a prominent feature that I wish was all included in one case.

Also designed to work with my pi camera mount remix.

Hardware

4 M2.5 x 12mm bolts I used these from Amazon
M2.5 x 10mm bolts would probably also work.

3 M4 x 8mm bolts I used these from Amazon

3 M4 T-Slot (Hammer) Nuts I used these from Amazon

Version 1

Link_Mod allows the link to rotate flush with the side of the lid - different from original links.

• PiCase_Lid - 20% infill (Print with supports for cable clip)
• PiCase_Base - 20% infill (Print with supports)
• Link_Mod - 100% infill

Version 2

Modified the lid to avoid printing supports for it.
PiCase_Lid_Adapter should slide into the hole in the lid.
Link_Mod allows the link to rotate flush with the side of the lid - different from original links.

• PiCase_Lid_v2 - 20% infill
• PiCase_Lid_Adapter - 100% infill
• PiCase_Base - 20% infill (Print with supports)
• Link_Mod - 100% infill

Version 3

Modified both the lid and case to support a vertical orientation.
PiCase_Lid_Adapter should slide into the hole in the lid.
Link_Mod allows the link to rotate flush with the side of the lid - different from original links.

• PiCase_Lid_v3 - 20% infill
• PiCase_Lid_Adapter - 100% infill
• PiCase_Base_Alt - 20% infill (Print with supports)
• Link_Mod - 100% infill