Original design belongs to Classy Goat over on thingiverse! It’s a very fun project!!!

Everything will require full supports except for Puzzle_bottom.STL!

Print Puzzle_bottom.STL and Puzzle_top.STL.

THEN DO ONE OF THE FOLLOW...

1. If you're going to glue on a 2D image, then print Blank_piece.STL 8 times and Blank_removable.STL once.You'll want your 2D image to be about 4.25 x 4.25 inches large.

2. If you're going to make a custom 3D image, then load Blank_piece.STL and Blank_removable.STL into your 3D modeling program, copy Blank_piece.STL so there are 8 total, and arrange them like this.

Then put your 3D image over it and cut it up using a plane cutter or whatever your 3D program might have.

Then put all the pieces together.

Recommended: #6 Machine Screws that are 1/2" long

and #6 hex nuts