Mounting solution (holder) for Mini PC like "HP 260 G2", "HP 260 G3" and all other VESA-compatible devices

I needed a simple and inexpensive solution for attaching a mini PC to a display. But branded mounts from HP are expensive, so this solution was invented.

This mount is great for devices and monitors with a VESA 100*100mm mount.

The use of this mount is not limited to the display only. You can use it on other surfaces: wall, table, under the table(!). When attaching to wooden surfaces, the screw must be replaced with a wood screw for of suitable length (for holder-final-part3.stl)

Additionally, 4pcs M412mm and 4pcs M415mm flat head screws are required (In my case).
The length of the screws may vary in your case (depending on the monitor and device)

The part holder-final-part1.stl must be screwed on without special effort, so that the part after installation can be turned 90 degrees down. See photos.

One mounting kit required:

holder_final_part1.stl - 1pcs
holder_final_part2.stl - 3pcs
holder_final_part3.stl - 4pcs