NodeMCU Multi-Sensor Case
rachel_thompson73
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2019-04-04 22:15:08
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
A revised version of the Bruh Automation and TrueOverFlow multi-sensor case that includes:
- Space for BH1750 light sensor
- Higher stand-offs for NodeMCU Amica board
- Pinch-clip at bottom of case to hold it together more effectively
Parts list to construct your own sensor:
- BH1750 light sensor
- AM312 PIR sensor
- NodeMCU v1 (Amica, NOT Lolin board)
- Red LED (used to show PIR triggered)
- 470 ohm resistor
- DHT22 Temperature/ Humidity Sensor
- Header wires (I'd suggest 10cm wires to get a nice "fit" inside the case!)
- USB Power Supply
- Large Fresnel lens
Use Tasmota as the firmware/ software. This works reliably with the attached GPIO configuration.
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY