Summary

An add-on to your electronic caliper.

Model has many ajustable parameters.

The gauge can be used to Router and Table Saw.

This is of course NOT a high precision solution, but it is quite flat and does its job within a 0.05mm error range.

Assembly and Use

The side hole for screw/bolt is 3.5 mm diameter, so you can screw in a M4 bolt/screw without the need to cut a thread.
If Caliper Mounting Type is hasp - used two screws M3 length 8-12 mm

• Insert the caliper and fix it with a screw/hasp.
• If necessary, install a heel on the caliper probe.
• Place the gauge on a smooth, flat surface.
• Lower the caliper probe until it touches the base surface.
• Zero the caliper. Now when you lift the probe, the height will be displayed (as a negative value)