Sega Controller Stand, I used as a reference the design created by M4RCCR4FT for the NES and SNES controllers (https://www.thingiverse.com/thing:3403304).

The logo is split in two pieces, the planet is part of the stand while the rings are in a second file, this will allow you to print and paint the rings separate from the body to make them stand out.

Before printing make sure you rotate the stand so it sits flat on the side, do not print it in vertical position (unless you want to use a lot of supports).

You may notice a difference between the STL and the actual photos, that's because the photos are from the 1st version I created and the STL file is an improved version.