Ring Light Bracket
harris1980
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-01-10 09:15:53
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
Designed these brackets after inspiration from bkvines (BV3D)'s video on YouTube. I already had a ring light but it was 31 mm thick. Too big for the original brackets.
I took the basic idea and drew up a new bracket in fusion 360 to accommodate my light while I waited for the amazon delivery of nuts. bolts, and a usb extension cable.
Sliced in prusaslicer with two instances of bracket and four channel covers as shown in original video.
My ender 3 v2 finished in about 5.5 hours and install took maybe ten minutes.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Infill:
15
Filament:
Comgrow TPLABlack
Notes:
I used optimal settings in prusa slicer but added supports and changed the bottom and top layer fill just for fun.
Also, I printed the bracket on its side with good results. I suppose you could try it standing up but your mileage may vary.
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC-BY