Simple multiboard brackets designed to hold flat panels up to 5mm thick. Designed for 1/8" / 3mm glass with rubber/foam strips on the edges.

I made this for the glass top panel of my Sovol Zero when it needs to be removed for printing low temp filaments like PLA and PETG.

Two bracket sizes are provided, 250mm and 150mm. Typically, more support is needed at the bottom, the top and “back” should only need a single small bracket.

These brackets install with Large flat head multiboard bolts. 9mm bolts work fine, I prefer to use the ones with medium push-fit holes in them, so I can use a long push fit hook as a wrench.

At minimum a bracket is needed at the bottom and one side. A third bracket at the top or the other side is recommended if the panel might be bumped or is subject to vibration.