This holder has been designed to enable lockpickers to orient a lock at 0, 45, 90, 135, 180, 225, 270, and 315 degrees. It was designed to test if there is an orientation that locks pick best at.

The build comprises of:

1 x Inner
1 x Outer
2 x Chocks - this is to prevent the inner holder from sliding out of the outer holder.
2 x Bars - one for the front of the lock and one for the rear. To attach the bar you will need 4 x 15mm M3 Screws

Print Settings

Printer:

GEEETECH A10

Rafts:

**Supports:** No

Resolution:

**Infill:** 38 Filament: 3D Printz PLA Red Post-Printing =============

Category: Other