Ducati Multistrada 1260 Wind Screen Spacers
em1ly
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-01-07 14:56:21
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
These are spacers for Ducati Multistrada windscreen that hold the screen about 23 mm above the stock mounting surface. They are intended to reduce helmet buffeting and should also fit 1200 and 950 V2 models. How well these work varies with the rider. Some guys swear by them, others don't. I have ridden my 1260S about 2500 miles with them installed now and they seem to help with buffeting and noise.
Print Settings
Printer Brand:
Creality
Printer:
K1
No
Supports:
No
40%
Notes:
I printed these out of carbon fiber infused PETG, with a 0.20mm layer height, outer brim, in the orientation shown in the last photo, with no supports.
The angled risers (print 2 of them) use the stock windscreen fasteners to connect to the bike. The screen attaches to the angled risers with 6mm bolts. They are set up to capture a 6mm nylock nut. The straight lower riser uses a 5mm x 0.8 fastener. Use fender washers under them on top of the stock grommets in the screen. I'll add bolt lengths when I figure them out.
These likely won't work with an aftermarket screen. I'll deal with that if/when I buy a touring screen to try out.
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC-BY-SA