A few types of clips to fit the hose of the Flux Integration ALLY industrial SCARA robot. These clip onto the hose that runs from the top of the robot base to the arm, they allow the neat reliable retention of cables and hoses that need to be run to the end effector.

For best results print a few of the size required and feed cables and wires so that the form a gentle arc to the toolhead while leaving enough slack for a full range of movement. The clips are made with grooves that lock into the hose on the ALLY robot, preventing unwanted movement.

2 x 4mm is designed to hold 2 x 4mm OD airlines
10mm, 15mm and 20mm are the diameters they can each hold.

The HAGEN logo helps orient the print. Make sure the text is the right way up on the print, so the clips can be printed without supports.

If you would like a specific design for your ALLY robot install please let us know!

Creality

CR-10S

No

No

0.2 or better

100 pc Triangles

Do not print with concentric infill or the clip will tend to delaminate or snap when being put on.