Remix of the toaster replacement knob by micrgl:

https://www.thingiverse.com/thing:561717

to fit my Philips HD 4880 toaster.

Printed this one in TPU, because I needed a knob and based on what filament I had on hand the choice was either TPU or PLA. Although it isn't anywhere near the hot bits, I though TPU might be a bit more robust.

As a plus, the TPU sort of expanded when I jammed the knob on, and gripped by itself, without needing and screws or glue, etc.

Would probably go OK in PETG or ABS as well, although you may need to glue it in place.

Print Settings

Rafts:

No

Supports:

Resolution:

0.1mm

Infill:

Notes:

Obviously I printed it fat end facing downwards to avoid using supports.

Category: Replacement Parts