Housing designed to fit a Runcam Split 2S in my TBS Caipirinha 2. It is based on the design by /u/petronioaznar but I could only get my hands on the smaller Split 2S so I had to create a new design. It was a pretty snug fit for me, but I still used a few beads of hot glue to secure it in place. You can secure the PCB with some M3 screws.

Edit: I added a file with the units in millimeters as the original file was in inches and could load super tiny depending on your software.

Lulzbot Taz 5

No

No

.25

15%